U-Joint Cap Snap

If you have ever pulled a driveshaft you likely have also either dropped the caps off a U-Joint or been stressed about finding a way to not do so. 

Say goodbye to sticky electrical tape and hello to the BroachWorx Cap Snap!

These are 3D printed and made for 1310 and 1350 U-Joints and are a great add to any gearheads toolbox. Simply snap them on when you need to have the shaft removed from the vehicle. You can also use these while on your rig. If you are leaving the shaft hooked to the transfer-case and driving with it daily, for a bit of added measure we recommend throwing a zip tie around the outside and body of the joint just for added precaution.